Manufactured according to IS:2251-1986 the taper gauges are used for inspection of male and female tapers to ensure a rigid fit of the components during operations.
Thread Gauges are used to inspect various thread profiles on shafts and bores to ensure a smooth fit. Provided with calibration certificates traceable to National standards on request
Akros Reversible pin gauges are precision ground to a diametrical tolerance of as low as 0.5µm. Used to inspect the geometry of bores.
Used for inspection of diametrical and thickness tolerances of parts and to establish their upper and lower limits.
Useful for aligning centres and testing runout of machine spindles Akros test bars are available in MT, ISO & HSK shanks precision ground for high accuracies
Single body construction allows for higher perpendicularity of the squares for inspecting parts within close tolerances. Conforming to IS:2103-1980 available with straight or bevelled edges
Used to check perpendicularity of a surface against a reference plane. The squares conform to BS939 Grade B or DIN875
A centre square is used to locate the centre of round objects with ease and accuracy. It consists of a body and a knife edge clamped together by means of rivets.
Mounted onto the milling machine's spindle the centre finder helps in locating the central axis of cylindrical workpieces for carrying out various operations.
A useful tool for locating part features on the workpiece Akros wiggler set comes with four attachments for varied applications.
Used for aligning machine spindles and locating part features Akros centre finders are precision ground to provide concentricity within 5 microns.
Spring calipers are used to refer dimensional measurements to other linear measuring tools; Available types: inside caliper, outside caliper and divider.
Centre punches are used for marking an indentation on a surface in order to guide the drill bit for a clean and smooth operation.
They are provided with a square head for a larger striking surface. Centre punches are used for marking an indentation on a surface in order to guide the drill bit for a clean and smooth operation.
Automatic centre punch can be used single handedly to mark recesses on a surface thus eliminating the need for a hammer.
Used for driving or removing solid pins and rivets fixed in bores. A number of sizes are available for matching bores. The drive pin punches are hardened and tempered to 45-55 HRC for optimal wear resistance.
With an overall length of 200mm, the long drive punches are used for driving or removing solid pins and rivets fixed in bores. A number of sizes are available for matching bores.
With a single body construction parallel punches are used for driving or removing solid pins and rivets fixed in bores. A number of sizes are available for matching bores.
Provided in a set of 28 pcs it is used for transferring a bore's centre onto the required surface.
Used for transferring a bore's centre onto the required surface. Tapered head allows the tool to be used across a range of bores with different diameters.
Used for driving a nail flush with the surrounding surface or slightly under it.
The square head provides larger striking surface for the hammer and prevent rolling. Used for driving a nail flush with the surrounding surface or slightly under it.
Used for removing hollow tension pins (tapered or rolled). The ball ends fit into the hollow pin preventing the pin from collapsing when struck.
Used for punching holes in gasket material, leather, rubber, canvas, cardboard, plastic and other soft material.
Akros Wad punches are useful for punching holes in soft material like gasket, rubber and plastic. Exit holes allow easy disposal of the cut material.
Used for stamping metal surfaces with alphabets or numbers. The sets are provided in plastic cases for easy handling and storage.
Useful for scribing lines and marking points on metal, wood and plastic surfaces for reference during various operations